Hydraulic Shearing Machines
|
Our Hydraulic Shearing
Machines Range |
|
|
"SANTEC' presents to you a range of most
technically advanced hydraulic shearing machines with all latest features as
per international standards.
Types of Hydraulic
Shearing Machines
The range of hydraulic shearing machine we offer are as follows :
Sheet Cutting Machines Or Shearing
Machines
These machines are stable, robust, all welded steel frame is of top quality
to meet all. International standards, electro hydraulic overload protection
& safety features make machines safer. Roller guide made of hardened &
ground EN 31 to provide better quality of cutting for longer time
Range: - 14 Gauss to 10 mm
Length: - 1250 to 6000 mm
» The stable robust,
all welded steel frame from ultra sonically tested plates are of top
quality. Raw & table designed with special inclined member & box
type struture for maximum strength.
» The top beam is guided by three point roller with replaceable
hardened liners for least wear. This eliminates lubrication of steel to
provide better quality of cutting for alonger time.
» Rake angle can be varied to permit shearing of higher
thickness than nominal capacity & facilitating distortion free shearing
of thin sheets.
» The fastest & eagiest way of blade clearance setting
without need of feeler gauge, which helps burr-free edges.
» Positive holding by hydraulic holddowns before shearing
avoids slippage of sheets & independent operation of holddowns for
clamping of sheet helps checking of mark without taking shear stroke
» Front gauging by dis appearing stoppers mounted on left
squaring arm. Robust, heavy & accurate back gauging to set cutting
width.
» Hydraulic cylinder are designed with both low & high
pressure sealing, hard chrome plated rod also with special type guide for
long life without leakage.
» Hydraulic components are of international quality standards &
assembled on specially designed compact mambold block for easy maintance.
|
Hydraulic Shearing Machines |
 |
» Main Drive Motor
» Electric Control Panel
» Operational Console
» Pre selector switch to adjust rake angle
» Lever operated blade clearance with calibration
» Fine stroke adjustment rod with limit switch
» Front sheet support
» Squaring arm on right end with steel rule
» Hardened transfer bar mounted on table
» Hold down cylinders
» Shadow light indicator
» Four edge HCHCR / HCSR blade Interchangeable & suitable
to shear mild and St. Steel
» Manual back gauge
» Motorised back
gauge with DRO
» NC back gauge with ball screw
» Second squaring arm on left side
» Front support with roller according to required length
» Rear sheet support
» Ball transfer table
» Degree protector for angular cutting
» Stroke counter
» Design with throat depth
» First fill of hydraulic oil
|
Our Hydraulic Shearing
Machines Range |
|
|
